Kodak Document Scanner 9500 with/without Image Manager 9500 Manual do Utilizador Página 68
- Página / 101
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
A-61124 March 1999 C-1
Appendix C Assigning Image Addresses
An image address may contain up to 15 characters, consisting of
a maximum of 12 digits and a maximum of 3 delimiters.
You must define the following four fields:
• Field A represents Level 1. Its value is incremented when a
document is assigned Level 1.
• Field B represents Level 2. Its value is incremented when a
document is assigned Level 2. In addition, the value of Field
A is reset to zero.
• Field C represents Level 3. Its value is incremented when a
document is assigned Level 3.
• Fixed Field contains fixed information, typically, the date.
Example: 0301.02.001.000 where:
Field A contains 000
Field B contains 001
Field C contains 02
Fixed Field contains 0301
The image address field lengths depend upon the Index Format
you select:
• Single Level Format
Field A is defined as having a field length greater than zero.
Field B is defined as having a field length of zero.
Field C is defined as having a field length of zero.
Fixed Field may be defined, if desired.
Example: FFFFFF.AAAAAA
• Two Level Offset Format
Field A is defined as having a field length of zero
Field B is defined as having a field length greater than zero.
Field C is defined as having a field length of zero.
Fixed Field may be defined, if desired.
Example: FFFFFF.BBBBBB
• Two Level Format
Field A is defined as having a field length greater than zero.
Field B is defined as having a field length greater than zero.
Field C is defined as having a field length of zero.
Fixed Field may be defined, if desired.
Example: FFFFFF.BBB.AAA
- Integrator’s 1
- 1 Introduction 2
- About this guide 3
- 2 Scanning Concepts 4
- Error handling 5
- A-61124 March 1999 2-3 6
- Fault recovery 7
- 3 Image Headers 8
- Image Addresses 9
- Assigning 9
- A-61124 March 1999 3-3 10
- Image header format 11
- A-61124 March 1999 3-5 12
- Default Image Header Format 13
- Retrieving images and 14
- Recommended retrieval 15
- Host to scanner 16
- Scanner to host 16
- SCSI data rates 16
- 5 The SCSI Interface 17
- SCSI interface signal 18
- Issuing SCSI 18
- A-61124 March 1999 5-3 19
- SCSI status responses 20
- SCSI message responses 21
- SCSI conformance 22
- SCSI commands 23
- Command block descriptor 24
- A-61124 March 1999 5-9 25
- Define Window Parameters data 26
- Get Window command 28
- Get Window descriptor bytes 30
- Get Window Parameters data 31
- Inquiry command 33
- Inquiry data 34
- Read command 35
- Release Unit command 36
- Request Sense command 37
- Request Sense data 38
- A-61124 March 1999 5-23 39
- Reserve Unit command 40
- Scan command 40
- Send command 41
- Using the Send 42
- Test Unit Ready command 43
- 6 Scanner-unique Commands 44
- Command summary 45
- A-61124 March 1999 6-3 46
- Commands 47
- BX/Y/Z — Scan resolution 48
- CX — Clear buffers 48
- DC — Sequential ID 48
- DX — No scan 49
- EX — Bit order 49
- FX/Y/Z — Compression 50
- GC — Last image 50
- GX — End of job 51
- HA — Set mode 51
- HC — Next image address 51
- JA — Define mode 52
- JX/Y/Z — Scan threshold 53
- KX/Y/Z — Scan contrast 54
- LX/Y/Z — Dither pattern 54
- (screen) 54
- MC — Count Only mode 54
- MX/Y/Z — Image 55
- NF — Level of next 55
- NX/Y/Z — Noise filter 55
- SX/Y/Z — Reverse image 56
- TX — Simplex/duplex 56
- YX/Y/Z — Border 57
- Reduction 57
- WX/Y/Z — Skew 57
- Correction 57
- Scanner-unique 58
- Recommended usage of 61
- Protocol 62
- Sample interfaces 62
- Appendix A Glossary 63
- A-2 A-61124 March 1999 64
- Kodak Digital Science 65
- A-4 A-61124 March 1999 66
- Ordering publications 67
- A-61124 March 1999 C-1 68
- C-2 A-61124 March 1999 69
- Image processing 70
- D-2 A-61124 March 1999 71
- Table D-2 — Scanner 9500 72
- Appendix E Image Processing 74
- Auto-cropping 75
- Scanner-unique Commands 77
- , Scanner-unique Commands 78
- Noise filter 80
- Resolution 82
- Screening/Dithering 83
- Adaptive Threshold 86
- Processor (ATP) accessory 86
- Image Manager capabilities 89
- Example 1 91
- Example 2 91
- 12 “ - Full width of Scanner 92
- Border reduction 93
- Skewed Document 93
- Scanned images 94
- Printed Images 94
- Computer-generated images 95
- Photographic images 95
- Evaluation criteria 96
- Staircasing 97
- Aliasing 97
- Image resolution 98
- Noise and dynamic range 99
- Brightness 100
- DOCUMENT 101
Manuais e produtos relacionados com Adaptadores de Transparências para Scanner Kodak Document Scanner 9500 with/without Image Manager 9500
(2 páginas)© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.028 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais