Kodak Digital Science 8650 Manual do Utilizador descarregar pdf (Página 38)

Setting up the printer

October 1997 2-23

Checking and changing printer settings

Before you make a test print—the last step in setting up the printer—

check that the printer settings are correct for the media you just loaded

and for the mode in which you are going to operate the printer.

This section describes only how to check and set the mode and media

options. For complete information about printer settings, see Chapter 3

in this guide.

You use the buttons on the printer’s display panel (shown below) to look

at and change the printer settings.

Changing the operating mode

If you have the PostScript version of the printer, the printer has two

operating modes: PostScript and raster. The PostScript mode is the

factory default.

To change the mode to raster:

1. Press Setup/Select when READY appears in the display panel.

2. Press Print to scroll down (or Cancel to scroll up) through the

settings until SETUP:MODE appears.

3. Press Setup/Select to access the MODE options.

Power

Error

Cancel

Setup/Selectscroll

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 109 110

Sem comentários

Kodak Digital Science 8650 Manual do Utilizador Página 38